10 Easy Steps to Repair a Hole in the Wall.

You will need a few tools and a bit of material.

Tools & Material

Drywall cutting blade

Drywall taping knife

Screwdriver or Drill

Trowel

Measuring tape

Tape or Fibafuse

Drywall compound

Drywall

Drywall srews

Wood for backing

This hole was cause during the drywall delivery .

As you can see in the picture on the right it is too big of a hole to be covered by a piece of tape .

Step 1

Measure the size of the hole.

Step 2

Cut the hole in a square or rectangular shape.

Step 3

Add backing to each side of the hole.

Screw it in place in the drywall.

Step 4

Cut a drywall piece 1/4 inch smaller than your hole.

Step 5

Screw it to the backing .

Step 6

Embed paper tape or Fibafuse over the seams.

In this example I use a 6 inch Fibafuse and only had to use a single piece.

Step 7

Remove all the excess of compound swipe it clean and neat .

Let it dry .

Step 8

Using a trowel or taping knife add a thin coat of drywall compound.

Let it dry.

Step 9

Sand edges with a block sander and repeat Step 8.

Step 10

Sand your final skim coat with a sanding sponge with a very fine grit.

Et voila ! It should be ready to prime.